Serbia’s distribution export bottleneck creates case for local flexibility

Supported byClarion Owners Engineers

Rapid growth in distributed electricity generation is beginning to expose reverse-flow constraints in parts of Serbia’s grid, strengthening the case for local flexibility markets that could use industrial demand, EV charging and other controllable loads to absorb power before expensive network reinforcement is required.

Elektrodistribucija Srbije (EDS) technical system director Dalibor Nikolić said this week that limits at parts of the distribution-to-transmission interface currently restrict reverse electricity flows to around 16 MW, while expected flows in areas including Banat and southern Serbia could exceed 30 MW.

Supported byVirtu Energy

The issue is emerging as distributed generation expands rapidly.

EDS now has around 498 power plants with combined capacity of about 540 MW connected to its network, alongside roughly 8,500 prosumers representing about 160 MW.

The numbers point to a change in the direction of electricity flows for which much of the distribution system was not originally designed.

Supported byClarion Energy

Traditional distribution networks were built primarily to move electricity from the transmission system towards consumers.

Increasing distributed generation means electricity can now move in the opposite direction.

Supported by

When local production exceeds local demand, surplus power moves through the distribution network and ultimately towards the transmission system.

That creates a new constraint.

The problem is not necessarily that Serbia lacks generation.

It is whether the grid can move electricity away from the location where it is being produced.

Local surplus creates local value

This distinction changes the economics of flexibility.

When a distribution area has excess production, increasing electricity consumption locally can be valuable even if national demand does not require additional power.

An industrial customer capable of moving production into a high-generation period could help absorb the surplus.

The same could apply to EV charging, water pumping, electric boilers, refrigeration, thermal storage and other flexible loads.

The value is therefore locational.

A 5 MW increase in demand in the right part of Banat could help relieve a local export constraint.

The same 5 MW increase elsewhere in Serbia may provide little benefit.

That is the fundamental logic behind local flexibility markets.

Instead of paying only for electricity as a national commodity, the system begins to value where consumption or generation changes occur.

Grid reinforcement is not the only option

The conventional response to increasing reverse flows is network investment.

Transformers can be replaced.

Substations can be reinforced.

Lines can be upgraded.

Those investments will still be necessary as Serbia adds more distributed generation.

But flexibility offers another option where constraints occur for only a limited number of hours.

If a transformer is overloaded during high solar output for 100 hours per year, immediately investing millions of euros in additional capacity may not always be the cheapest solution.

EDS could theoretically procure additional consumption or temporary generation reductions during those hours.

The cost of the flexibility contract could then be compared with the cost of network reinforcement.

That is the concept of a non-wire alternative.

The approach is increasingly used in more mature electricity markets but remains at an early stage in Southeast Europe.

Serbia now has the physical conditions that could justify testing it.

Dynamic export limits could emerge

One potential solution is flexible or non-firm connection rights.

Instead of allowing a distributed generator to export its full capacity at all times, the DSO could grant a larger connection subject to temporary restrictions when the local network is congested.

A solar installation might therefore receive permission to connect faster but accept that export can occasionally be limited.

The alternative is waiting for full network reinforcement.

This converts grid capacity into a contractual product.

A developer chooses between firm and flexible access.

The decision then becomes part of the project economics.

A plant expecting only limited annual curtailment may accept a non-firm connection if it allows earlier operation.

Other projects may require guaranteed export capability to satisfy lenders.

Serbia does not yet have a mature market for such products, but growing reverse-flow constraints make the issue increasingly relevant.

Demand could be cheaper than curtailment

Another response is to create demand where distributed generation is concentrated.

Industrial electrification could therefore become part of grid planning.

Electric boilers and thermal-storage systems can absorb electricity during periods of high local renewable production and release the energy later as heat.

Cold-storage facilities can increase refrigeration earlier and reduce compressor demand later.

Water utilities can move pumping into surplus periods.

EV fleets can charge when local generation is abundant rather than simply following a fixed night tariff.

None of those assets needs to be constructed solely for grid support.

The flexibility comes from changing when existing or planned electricity consumption occurs.

This can reduce both renewable curtailment and network reinforcement needs.

Aggregators could connect small loads

Most individual consumers will be too small to contract directly with EDS.

That creates a potential role for aggregators.

An aggregator could combine dozens of commercial and industrial sites connected beneath the same constrained part of the network.

The portfolio might include refrigeration, HVAC systems, pumps, batteries and EV chargers.

EDS would procure a required response from the aggregator rather than managing hundreds of individual customers.

The aggregator would then determine which assets should respond.

That reduces transaction costs and gives smaller customers access to flexibility revenue.

But the model depends on smart metering and accurate network visibility.

EDS needs to know not only that demand changed but that it changed at the location where the grid required relief.

Local flexibility therefore requires more granular data than conventional national balancing.

Serbia has the constraint before the market

The important feature of Serbia’s current position is that the physical problem is appearing before a mature commercial mechanism exists to solve it.

Distributed generation is already growing.

Reverse flows are already rising.

EDS has now quantified network pressure in areas where expected flows could move beyond present operating limits.

Yet local flexibility remains largely a regulatory and market-design question rather than an established product.

That gap creates the next policy challenge.

The regulator and network operators will eventually need to determine whether local constraints should be addressed only through conventional investment or whether distribution-connected flexibility should become a procured service.

If procurement develops, several questions follow.

How far ahead should EDS contract flexibility?

Should providers receive availability payments, activation payments or both?

How should baselines be calculated?

Can a flexible asset simultaneously participate in national balancing and a local DSO contract?

Who has priority if EMS and EDS want the same MW at the same time?

Those are the questions that turn demand response into a functioning market.

Banat could become an early test

Areas such as Banat, with increasing distributed generation and potential reverse-flow pressure, could provide a natural location for pilot procurement.

The objective would not need to be creation of a large national flexibility exchange immediately.

EDS could begin by publishing specific local needs.

A tender might state that a defined network area requires, for example, 10 MW of additional consumption or reduced export between 1100 and 1500 during selected high-generation periods.

Industrial users and aggregators could then bid to provide it.

The network operator would gain a transparent price for flexibility.

That price could be compared with the cost of reinforcement.

Serbia would also gain real operating data before designing a wider market.

The broader significance goes beyond the current 16 MW constraint.

As distributed production continues to increase, electricity networks will need to manage power flows in both directions.

The cheapest solution will not always be another transformer or cable.

In some locations, the most valuable grid asset could instead be a factory, charger or heating system willing to consume electricity at precisely the moment the local network needs it.

Supported by

RELATED ARTICLES

spot_img
spot_img
Supported byClarion Energy